The Speedy Stitcher Sewing Awl is the perfect tool for assembly and quick repairs. It makes sewing through heavy or light materials easy to do and a snap to learn. Once you master the technique, you'll never want to sew without it. Follow the steps below to get started on your project.
If you need to get your awl setup and your project ready for stitching, read through our helpful tips here.
1. Starting from the back side, push the needle through the material of your project. On the front-side, fully draw out the thread, long enough to do the entire project - remember to add an extra 3" of the thread.
2. While keeping your thumb firmly over the thread on the handle of the awl, hold the thread and pull the needle back out of the hole. Then start it through the second hole.
3. Push the needle through the second hole as far as it will go. Then pull back slightly on the awl just until a loop is formed.
4. Pass all of the thread through this loop.
5. Hold the thread end taut. Pull the needle out of the hole, forming a lock-stitch. Pull taut, the lock-stitch knot should be buried in the middle of the fabric layers.
6. Release more thread between the needle and material to allow for the next stitch. Continue this process until your project is finished.
7. After the last hole on the back side of your project, grasp the loop and pull the thread out of the hole.
8. Cut the thread, leaving two 3" lengths to tie off.
9. Tie the ends in the knot on the back side. Trim the excess thread.
10. To safely store the Speedy Stitcher sewing awl, remove the needle from the threaded post and place it back in the appropriate slot. Screw the chuck lock back in place. Presto!
You can download our step-by-step guide including helpful tips and tricks for using the Speedy Stitcher below.